Karelsky Okatish – Station Kombinatskaya | Russia

With the station Kombinatskaya located in the Murmansk region in North West Russia, the operator faced major challenges given the environmental conditions: These demanded outdoor equipment with minimum maintenance that can operate with highest levels of reliability and precision, as it would be exposed to the extreme cold weather, including snow. Reliable and continuous operation was achieved by replacing the track circuits with a Frauscher Axle Counter Solution.

As modern axle counters are replacing an increasing number of track circuit installations worldwide, this project is a good example to indicate their advantages for customers who demand a robust and reliable solution with minimal maintenance requirements.

After a successful trial with the Frauscher Advanced Counter FAdCi in combination with the Frauscher Safe Ethernet FSE protocol and the Wheel Sensor RSR180, the customer decided to replace the track circuits in their railway network.

The FAdCi is designed for industrial lines as well as for regional and metro lines and represents a cost-effective SIL 3 safety solution that is limited to train speeds of 80 km/h. For this project, a central architecture was established with all indoor components being installed in one location.

With regards to the extreme weather conditions on site, existing detection points were replaced with the Wheel Sensor RSR180, a time-proven solution with minimal maintenance. As a result, the Frauscher Axle Counter Solution requires a single maintenance visit every two years concerning areas where train movement is not expected within this period, as regular train passing confirms the correct operation.

Reliability and robustness

The track side equipment of the FAdC ensures reliable and continuous operation even under exposure of extreme cold weather and snow.

Low maintenance

Maintenance-intensive components are rated as major cost drivers, as is high power consumption. The FAdC in combination with the FSE protocol minimises lifecycle costs through preventive maintenance to support the customers challenges.

Easy and cost-effective integration

Universally applicable hardware interfaces and high-performance software interfaces enable the fast integration of our axle counters in various applications. The customer decided to use the FAdCi in combination with the FSE protocol as cost-effective SIL 3 safety solution.

Project details
Operator
Karelsky Okatish
Country or region
Russia
Partner
Promzheldoravtomatika
Segment
Industrial & Mining
Axle Counting
Frauscher Advanced Counter FAdC, Frauscher Safe Ethernet FSE
Wheel Detection
Wheel Sensor RSR180
Application
Track vacancy detection
Year
2020
Number of Sensors
33
Similar projects

This might also interest you

Frauscher Train Detection Metro Warsaw

Metro Warsaw | Poland

Metro Warsaw was looking for an alternative to track circuits for the line M2, to increase the availability of public transport by using reliable signalling technology. In the end, the operator even decided to replace the existing track circuits on line M1 with the Frauscher Axle Counter ACS200.

Dillinger Hütte | Germany

A new ladder track was required to provide more parking tracks in the steel plant. At the same time, the layout of the dead end tracks were optimised and the efficiency of the whole depot improved by installing the Frauscher Advanced Counter FAdCi in combination with the wheel sensor RSR180. With the implementation of the Frauscher Diagnostic System FDS, the overall maintenance costs can be significantly reduced.

Edmonton Metro Line | Canada

The Edmonton Metro Line was experiencing significant issues with its newly installed Communications Based Train Control (CBTC) signalling system, which did not perform to the operator‘s expectations. The city was forced to run an incomplete schedule with reduced train speed and frequency which negatively affected commuters and the city of Edmonton in general. Finally in 2019, the operator decided to install a new system in cooperation with Frauscher.